Nexo LS18 - Manual (Page 61)

GEO S12 HARDWARE SETUP PROCEDURE Page 61/103
IMPORTANT
GEO S12 can be flown “Left” or “Right” :
-
“Left” means Nexo logo on front grid is left as seen from front;
-
“Right” means Nexo logo on front grid is right as seen from front.
GEO S12 can be connected to bumper “Left” or “Right” by simply flipping the cabinets.
Whenever possible, NEXO recommends symmetrical designs (preferably NEXO logo
outwards in stereo configurations)
LS18s are always flown upwards (ie with NEXO logo properly oriented and pole stand
hole up)
 Connect bumper to first LS18 or GEO S12 using “lift” points of XBOWs; ensure quick
release pins are properly locked;
 Insert axis in bumper NS-1 predefined hole and secure it with provided “R” clip;
NB: Bumper holes are numbered #-17 to #17, please refer to NS-1 to determine axis position in
relation to bumper angle requirements.
If bumper is flown with 2 hoists, then they should be connected to holes #-17 and #17.
 Connect hoist hook to bumper axis and lift assembly to sufficient height in order to
connect a second LS18 or GEO S12;
 Connect second LS18 or Geo S12 with X-Bow front articulation holes and rear link bars
and ensure quick release pins are properly locked;
 Repeat above steps for subsequent cabinets.