Hired-Hand RS-300 Door - Manual (Page 12)

Part No. 4801-5157 Rev 11-05 RS-300 Door Page 12 of 30
OP
EN
CLO
SE
Warning!
NEVER RELEASE CHAIN!
If Chain Is Released, Door Will Drop With Rapid Motion. Injury May Occur If Chain Is Released!
Do not remove the cable tie securing the chain to the chain guide until after the chain bracket is
completely installed and the chain is secure.
Remove and discard the cable tie securing the chain to the chain guide prior to manual
operation.
6.2 Manual Chain Hoist Installation
Install Chain Bracket
1. Position chain bracket at height to allow chain to
hook into bracket as shown in Figure 7.
2. Securely fasten chain bracket to wall with screws.
Manual Operation
1. While securely holding the chain, cut the shipping
cable tie from the chain to the chain guide.
2. Carefully pull chain in direction of arrow (Figure 7)
to Open (Raise) door.
CAUTION! Never release chain while door is being
raised!
3. When door is fully raised, securely hook chain into
bracket as shown in Figure 8.
4. To Close (Lower) door, securely hold chain. Unhook
chain from bracket. Gradually close door.
NOTE: Maintain tension on chain while door is
lowered to prevent rapid drop of door.
Figure 8
Right Track
!
Figure 7
Side View