Hired-Hand RS-300 Door - Manual (Page 25)

Part No. 4801-5157 Rev 11-05 RS-300 Door Page 25 of 30
Inside
Curtain
Outside
Curtain
Outside
Curtain
Center
Curtain
Inside
Curtain
Detail 3
Bottom Bar
Detail 1
Center
Curtain Main Drive
Roller
Fig. 24
Curtain Installation
Hook & Loop
Strip
Hook & Loop
Strip
Hook & Loop
Strip
Outside Curtain
Center Curtain
Inside
Curtain
Detail 2
Pan headek
Screw
9. Installation of Replacement Curtain Material
1. Identify the three curtain panels as shown in Figure
24, Detail 1. The center panel has a hook & loop
strip across the top. The center panel does not have
hook & loop strips on the sides.
The inside & outside panels have hook & loop
strips at the top, and hook and loop strips along the
sides of the panels.
The outside panel may be identified as the longer of
the two panels.
NOTE: Prior to removing the old panel, close the
door (panel down) and observe how (a) the
inside curtain is bolted to the back-plate, (b)
how the center curtain is screwed to the main
drive with pan-head screws, and
(c)
how the
outside curtain is screwed to the front bar.
Once the new panels are adjusted using the
hook & loop strips, reinstall the same bolts and
screws as they were removed from the old
panel.
2. To install the curtain material, take the inside
curtain (Detail 1 and Detail 2), and attach the
material to the backplate.
3. After the inside curtain has been attached, take the
center curtain (Detail 1 & Detail 2), and attach the
center curtain to the drive roller.
4. Take the outside curtain, (Detail 1 & Detail 2), and
attach the outside curtain to the top bar.
5. After the curtain has been secured, install the
bottom bars in the curtain as shown in Detail 3.
The front bar should be installed first. The back bar
should then be installed, and should be above the
front bar.