Hired-Hand RS-300 Door - Manual (Page 17)

Part No. 4801-5157 Rev 11-05 RS-300 Door Page 17 of 30
8.2 Installation of Manaras Operator
The Manaras Operator has two sets of mounting holes: outside the frame for wall mounting and inside the frame for
hood mounting.
To open the control box cover, loosen the screw at the base of the cover. If the cover cannot be fully opened, the
retaining cam may be used to hold the cover in other positions. Refer to Figure 13, Control Box Cover Opening.
After installation, verify that there is no obstacle in the way when opening the control box cover. If an obstacle
exists preventing the cover from opening, it is possible to remove the cover by cutting the plastic hinge at its thinnest
point or unscrewing it from the box before putting the operator on the wall or hood. Closing the cover will also
require using two supplementary screws. Refer to Figure 14, Hinge Elimination And Cover Fastening By
Screws.
Figure 13 Control Box Cover Opening
Cut the hinge
lengthwise.
Remove the two
screws Replace two
screws to fix
the cover.
Figure 14 Hinge Elimination And Cover Fastening By Screws
or