Hired-Hand RS-300 Door - Manual (Page 9)

Part No. 4801-5157 Rev 11-05 RS-300 Door Page 9 of 30
Unassembled
Parts
Horizontal Member
(Hood Section)
Left track
(Flange side up)
Bracket fits to
inside of track
Bracket attached to front
of hood fits to the outside
of track.
Threaded
Pins
5.5 Assembly of Parts
CAUTION: Do not remove the cable tie securing the chain to the chain guide (for Manual
Chain Hoist Doors) or cable ties around the horizontal member (for Manaras
Operator Doors) at this point. The cable ties must hold the curtain inside the
horizontal member until assembly and mounting is complete.
1. Arrange the horizontal member (Hood Section), left vertical member (left track), and right
vertical member (right track) on the floor in front of the clear opening as shown in Figure 4
with the flange side facing upward.
2. At each end of the Horizontal member, there are two brackets. Refer to Figure 4 shown
below. One bracket attaches to threaded pins inside the track flange. The other bracket (on
the front of the hood) attaches to threaded pins on the outside of track unit. Attach hood to
track unit.
3. Add nuts to threaded attachment pins. Tighten nuts securely to 90 in-lbs torque.
CAUTION: Excessive torque will damage the threaded pins. Do not over-tighten.
4. Repeat steps 1-3 to install right track.
Right Track
Left Track
Lay tracks flat with
the flanges on top.
Hook & loop strips
go to inside of
door.
Flange mounting
bracket should be on
top side of track unit.
Clear Opening
Placement of Parts for Assembly
Lay left track, right track, and horizontal
member face down in front of the clear opening
as shown.
Figure 4
Frame Assembly
Hood section
(Curtain included)