5 transport and storage, 1 transport of the pyrometer, Transport and storage – LumaSense Technologies IGA 740 User Manual

Page 17: Transport of the pyrometer, 5transport and storage

Advertising
background image

Transport and Storage

KLEIBER 740

13

5

Transport and Storage

5.1

Transport of the pyrometer

Prepare the pyrometer for transport as follows:

1. Switch the pyrometer off so that there is no tension and remove the connecting cable

and the signal cable.

2. In case of usage of water cooling please remove the cooling water pipes from the

cooling water connectors and remove the water from the pyrometer.

3. Pivot the optics completely and lock these with the adjusting ring.

4. Protect the optics against scratches through suitable measures (e.g. protective cap,

foil, …).

5. Pack the pyrometer in the original packaging paying attention to the means of

transport (see transport instructions below).

The pyrometer is thus ready to be shipped.

It is advisable to use the original packaging for the shipping of the pyrometer. If the original
packaging is no longer available, the pyrometer should be shipped in a cardboard box with
shock-absorbing PE material.

When transporting the pyrometer observe the following instructions:

Take great care when transporting the pyrometer to avoid damage through the effect
of force, or careless loading or unloading.

Avoid jerks, vibrations and the formation of condensed water due to severe
temperature deviations while transporting.

In the case of overseas shipping, a suitable desiccator (e.g. Silicagel) should be
inserted and the pyrometer should be sealed together with the desiccator in a
protective plastic sheet.

If the pyrometer is not immediately installed after delivery and put into operation, then
it should be carefully stored in a location protected against dust and humidity (storage
conditions - see section 5.2).

CAUTION

Environmental factors, impacts and the formation of water condensation may damage some
components!

When transporting the pyrometer, take suitable measures to protect all components from
environmental factors, impacts and the formation of water condensation! Temporary
storage of the pyrometer in the open air is not permitted!

Advertising