Parts list, Use and care, Assembly – Nature Power Solar Motion Light 600 Dual (22060) User Manual

Page 3

Advertising
background image

Page 3

Page of 6

3

 

PARTS  LIST  

 

 

 
 
 

 
 

 
 

USE  AND  CARE  

Do  not  modify  the  Solar  Light  in  any  way.  Unauthorized  modification  may  impair  the  function  and/or  safety  
and  could  affect  the  life  of  the  equipment.  There  are  specific  applications  for  which  the  Solar  Light  was  
designed.  

Always  check  for  damaged  or  worn  out  parts  before  using  the  Solar  Light.  Broken  parts  will  affect  the  Solar  
Light  operation.  Replace  or  repair  damaged  or  worn  parts  immediately.  

Store  idle  Solar  Light.  When  Solar  Light  is  not  in  use,  store  it  in  a  secure  place  out  of  the  reach  of  children.  
Inspect  it  for  good  working  condition  prior  to  storage  and  before  re-­‐use.  

 

ASSEMBLY    

1.

Lamp  Unit  Installation  

Mounting  your  light  requires  a  screwdriver,  pencil  and  (in  some  circumstances)  a  power  drill.  

Place  the  mounting  bracket  on  the  surface  you  wish  to  mount  to.  

Mark  with  a  pencil  the  position  of  the  mounting  bracket  screw  holes.  This  will  enable  you  to  pre-­‐drill  

your  screw  holes.  

Once  the  mounting  bracket  is  installed,  ensuring  all  screws  are  tight,  you  are  ready  to  position  your  COB  

Security  Light.  

Carefully  route  the  wire  from  the  solar  panel  to  the  lamp  and  plug  it  into  the  power  socket.    

Adjust  the  motion  sensor  to  your  desired  position.  Your  COB  Security  Light  is  now  installed  and  ready  to  

charge.  

 

Note:  Lamp  unit  should  be  mounted  6.5  ~  9.8ft  from  the  ground  to  ensure  motion  detection  is  optimized.    
 
2.

Solar  Panel  Wall  or  Roof  Mounted  Installation    

Choose  an  area  that  receives  the  maximum  amount  of  sunlight  possible.  

Use   the   holes   located   on   the   solar   panel   mounting   bracket   to   mark   the   mounting   surface   for  

installation.    

Set   the   bracket   on   the   surface   you   have   chosen   and   secure   it   in   place   with   the   screws   and   anchors  

provided.    

Adjust  the  angle  of  the  Solar  Panel  to  ensure  it  receives  optimum  sunlight.    

 
Note:  The  Solar  Panel  is  equipped  with  a  5  ft.  wire.  The  maximum  distance  between  the  lamp  unit  and  solar  panel  
can  be  5  ft.    

Part#  

Description  

Qty.  

1  

Lamp  

1  

2  

Solar  Panel  (5m  Wire)  

1  

3  

Screws  and  Anchors  

1  

4  

Mounting  Bracket  

1  

5  

Manual    

1  

Advertising