Nature Power 60 LED Solar Security Light (22050 ) User Manual
Page 4
Version 1.1
Troubleshooting
If 60 LED Solar Security Light does not illuminate when movement in front of the sensor is obvious please observe the following.
Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours.
Clean solar cells with a damp towel, Do not apply excessive pressure and avoid the use of any solvents or cleaning agents on
the solar cells.
Ensure switch is set to ‘Auto’.
Check batteries are installed correctly.
Allow Panel to charge in direct sunlight for 2 days to confirm the batteries are fully charged.
Replace Batteries.
Note: Rechargeable batteries may last up to 800 charges. For best performance replace batteries every 12 months
Replacing Batteries
1. Batteries are located in the battery housing located at the front of the lamp (5) Fig 3.
2. Remove screws from front of the battery housing to access batteries.
3. Replace batteries with rechargeable batteries of the same type and rating.
4. Reassemble battery housing.
Maintenance
Ensuring the lamp is kept clean will optimise performance
Clean Solar cell with a damp towel, Do not apply excessive pressure.
Do not use any solvents or cleaning agents on the solar modules.
Safety Information
Do not install close to flames or flammable gasses
Keep away from children
Do not install on a unstable surfaces/position
Do not stare directly at the lights while they are on
To prevent the unit from falling, install the base unit tightly with expansion screw
Solar Security light, cannot prevent crimes, its invented to alarm use of motion
Do not install in close proximity to other light sources
Limited Warranty
Proof of purchase required
Nature Power warrants to the original purchaser that this product is free from defects in materials and workmanship
for a period of 1 year from date of purchase.
For more information contact:
Nature Power Products
1-800-588-0590
Scan me for more information