GW Instek GDS-2000A series Option User Manual - Manual (Page 69)

LOGIC ANALYZER
69
Trigger Settings
Serial Bus Trigger Settings
UART BUS Trigger Settings
The UART bus trigger conditions can be set at any time after the
bus settings have been set to UART.
Panel Operation 1. Set the Bus to UART in the bus
menu.
Page 54
2. Press the Trigger Menu key.
Menu
3. Press Type from the bottom menu.
4. Press Others from the side
menu and select Bus.
5. Press Trigger On and select the
triggering condition for the UART
bus.
Trigger On Tx Start Bit, Rx Start Bit, Tx End of
Packet, Rx End of Packet, Tx Data,
Rx Data, Tx Parity Error, Rx Parity
Error
Trigger On – Tx
Data, Rx Data If Tx Data or Rx Data was configured for the
Trigger On setting, then the number of bytes and
data can also be configured.
1. Press Data from the bottom menu.