GW Instek GDS-2000A series Option User Manual - Manual (Page 70)

GDS-2000A Series Options Manual
70
2. Press Number of Bytes from the side
menu and choose the number of
bytes for the data.
UART 1~10 Bytes
3. Press Data from the side menu to
edit the triggering data.
To edit the data, use the Variable
knob to highlight a binary or hex
digit and press Select. Use the
Variable knob to choose a value for
the digit and press Select to
confirm.
VARIABLE
Binary 0,1,X (don’t care)
Hex 0~F, X (don’t care)
ASCII ASCII characters for
the equivalent Hex
characters 00 to FF
The Trigger on settings will be reflected on the
Trigger Configuration icon.
I 2 C Bus Trigger Settings
The I 2 C bus trigger conditions can be set at any time after the bus
settings has been set to 1 2 C.
Panel Operation 1. Set the Bus to I 2 C in the bus menu. Page 56
2. Press the Trigger Menu key.
Menu
3. Press Type from the bottom menu.