GW Instek GDS-2000 series Programming manual - Manual (Page 38)

GDS-2000 Series Programming Manual
38
:COPY
This command is equivalent to pressing the HARDCOPY button which located on
the front panel of the oscilloscope. This command sends a copy of the screen
display, oscilloscope settings, or raw data to the flash disk or printer which specified
by :HARDcopy:MODe.
Both format and layout of the output are specified
with :HARDcopy:INKSaver, :HARDcopy:LAYout, and :HARDcopy:RATio
commands.
Syntax
:COPY
:CURSor:X<X>Position
Adjust the cursors position of X axis.
Syntax
:CURSor:X<X>Position <NR1>
:CURSor:X<X>Position?
Arguments
<X>→Specify the cursor (1|2)
<NR1> is the desired position. For x-axis operation, the range is 1 to 249 when
MENU ON/OFF button is turned on; the range is 1 to 299 when MENU ON/OFF
button is turned off.
Returns
<NR3>→Returns position value of T1 or T2.