KANOMAX 2211 Handheld IAQ Monitor - Manual (Page 26)

21
6.3 Print Out
You can connect IAQ Monitor to a printer using an RC232C cable
for data printout.
6.3.1 Preparation
<Need to have>
- Printer (optional)……….. DPU-H245 (Seiko Instruments) - recommended
- Printer Cable （optional）
<Check the Baud Rate >
You need to coordinate the baud rate and data transmission conditions on both Main Body and the printer.
The factory setting of Main Body is as follows:
Data-bit length 8-bit
Parity None
Stop Bit 1
Delimiter CRLF
Baud Rate
Base on setting value
※ To change the BAUD RATE, refer to P.34 “Units and Baut Rate”.
For the setting of printer, refer to printer’s operation manual.
<Connecting Printer>
①
Connect printer to Main Body using an RS-232C cable.
② Turn ON the IAQ Monitor first, and then turn ON the printer.
③ Make sure that the IAQ Monitor is displaying NORMAL Mode.
6.3.2 NORMAL Mode Print Out
Display Procedure
Press to HOLD the display.
Press to print out.
If printer is not connected properly, you will find “PERR” in lower
left side of the display.
RS232C Port