KANOMAX 2211 Handheld IAQ Monitor - Manual (Page 32)

27
6.4 Digital Output
6.4.1 Preparation
You can download the data stored in IAQ Monitor to your PC, by connecting
IAQ Monitor and your PC with the RC232C cable.
<Need to Have>
- Computer
- RS-232C cable (provided)
- Data Processing Software （Software for Windows DC-ROM is provided）
<Check the Baud Rate >
You need to coordinate the data transmission conditions on both Main Body and your PC.
The factory setting of Main Body is as follows:
※ To change the BAUD RATE, refer p.34 “Units and Baud
Rate”.
For setting your PC, refer to the operation manual of your PC
＜
Connecting PC＞
① Connect PC to Main Body using an RS-232C cable.
② Turn ON the IAQ Monitor.
③ Make sure that the IAQ Monitor is displaying NORMAL Mode.
Make sure that the IAQ Monitor is displaying NORMAL Mode.
RS232C Cable Wiring Diagram
PC (D-Sub9 pin) IAQ Monitor （MODEL2211）
Signal Pin No.
Connection
Pin No. Signal Purpose Direction
NC 1 1 GND Ground
RXD 2 2 TXD Transmitting Output
TXD 3 3 RXD Receiving Input
NC 4 4 CTS Transmission Approval Input
GND 5 5 RTS Transmission Request Output
NC 6 6 NC
RTS 7
CTS 8
NC 9
Data Bit Length ８ bits
Parity None
Stop Bit 1
Delimiter CRLF
Baud Rate Bace on the setting
RS232C Port