Document Outline

• 1. Total Access 600 Overview
  • Analog Lifeline
  • Firmware Updates
• 2. Voice Over DSL Overview
• 3. Voice Over ATM Overview
• 4. Voice Over DSL Application
• 5. Configuring the Total Access 600
  • System Info
    • > System Name
    • > System Location
    • > System Contact
    • > Unit Name
    • > CLEI Code
    • > Part Number
    • > Serial Number
    • > Firmware Revision
    • > Bootcode Revision
    • > System Uptime
    • > Date/Time
  • System Config
    • > Network Timing Mode
      • Network
    • > Telnet Access
    • > Telnet User List
      • Name
      • Authen Method
      • Password
      • Idle Time (1-255)
      • Level
    • > Maint Port Menu
      • Password Protect
      • Password
      • Baud Rate
      • Data Bits
      • Parity
      • Stop Bits
    • > Network Time
      • Server Type
        • NT Time
        • SNTP
      • Active
      • Time Zone
      • Adjust for Daylight Saving
      • Host Address
      • Refresh
      • Status
  • System Utility
    • > Upgrade Firmware
      • Transfer Method
      • TFTP Server Address
      • TFTP Server Filename
      • Transfer Status
      • Start Transfer
      • Abort Transfer
    • > Config Transfer
      • Transfer Method
      • Transfer Type
      • TFTP Server IP Address
      • TFTP Server Filename
      • Current Transfer Status
      • Previous Transfer Status
      • Load and Use Config
      • Save Config Remotely
    • > Ping
      • Start/Stop
      • Host Address
      • Size (40-1500)
      • # of Packets
      • # Transmits
      • # Receives
      • %Loss
  • Configuring WAN Settings
    • > DSLAM Type
    • > Layer One Interface
    • > Layer Two Protocol
    • > ATM Config
      • Idle Cells
      • Data Scrambling
    • > ATM Stats
      • AP: Tx Cells
      • AP: Rx Cells
      • AP: Rx OAM Cells
      • AP: Receive Cells Discarded
      • AP: Receive Cell Errors
      • AP: Sync
      • AP: Out Of Cell Delineation
      • AAL5: Transmit Frames
      • AAL5: Receive Frames
      • AAL5: Transmit Discarded Frames
      • AAL5: Receive Errors
      • AAL5: Receive Discarded Frames
      • AAL5: No ATM Frames
      • AAL5: No Data Packets
      • Clear Stats
  • Configuring the Router – Configuration
    • > Global
      • IP
        • Mode
        • Static Routes
        • DHCP Server
        • Domain Names
        • UDP Relay
          • Mode
          • UDP Relay List
      • Bridge
        • Mode
        • Address Table
      • Security
        • Filter Defines
          • Filter Defines /MAC Filter Defines
          • Filter Defines /Pattern Filter Defines
          • Filter Defines /IP Filter Defines
    • > Ethernet
      • IP
        • IP Address
        • Subnet Mask
        • Default Gateway
        • RIP
        • Proxy ARP
      • MAC Address
    • > WAN
      • L2 Protocol
      • ATM
        • Description
        • VPI
        • VCI
        • PCR (Peak Cell Rate)
        • QOS (Quality of Service)
        • Protocol
        • RFC1483 IP
          • Active
          • Far - End IP Address
          • IP netmask
          • Local IP Address
          • NAT
          • RIP
      • RFC 1483 Bridge
      • PPPoATM
        • Authentication
          • TX Method
          • TX Username
          • TX Password
          • RX Username
          • RX Password
        • IP
          • Mode
          • Local IP
          • Netmask
          • Remote IP
          • NAT
          • Route
          • RIP
        • PPP
          • VJ Compression
          • Max Config
          • Max Timer
          • Max Failure
          • Encapsulation
        • Filters
          • WAN-TO-LAN (In)
          • In Exceptions
          • LAN-TO-WAN (Out)
          • Out Exceptions
  • Configuring the Router – Status
    • > Session
    • > ARP cache
    • > Bridge Table
    • > IP Routes
    • > LAN Stats
    • > IP Stats
  • Configuring the Router – Logs
    • Sys log Host
      • PPP Log
      • Connection Log
      • Network Log
        • Active
        • Wrap
        • Level
        • View
        • Clear
  • Configuring Voice Support – Config
    • > Call Control
    • > VPI
    • > VCI
  • Configuring Voice Support – Status
    • > Gateway Stats
    • > PVC Stats
    • > POTS Stats
    • > Clear Stats
  • Managing the Modules – Modules
    • > NET (SHDSL)
      • Menu
        • Data Rate
        • Frame Mode
        • Annex A/B
        • ITU-991.2/Gspan
      • Test
        • Network Loopback
        • Send/Check 2047
        • Send/Check ALT
      • Status
        • Signal State
        • Data Rate
        • Frame Mode
        • G.hs State
        • G.hs Event
    • > FXS
    • > EC/ADPCM
  • Managing the Modules – V.35 Setup
    • > ATM/FR IWF
      • Mode
        • FRF5
        • FRF8
      • Configuration
• Appendix A. Updating Total Access 600 Firmware using XMODEM
  • Updating Firmware via a Forced Download
  • Updating Firmware via the Console Menus
• Appendix B. Updating Total Access 600 Firmware using TFTP
• Appendix C. Navigating the Terminal Menus
  • Terminal Menu Window
    • Menu Path
    • Window Panes
      • Window Pane Navigation
      • Right Window Pane Notation
    • Additional Terminal Menu Window Features
  • Navigating Using the Keyboard Keys
    • Moving through the Menus
    • Session Management Keystrokes
    • Configuration Keystrokes
    • Getting Help
• Appendix D. Voice Gateway Quick Start Procedure (Voice Turn up)
  • Voice Turn Up
• Appendix E. RFC1483 Quick Start (IP Routing)
  • IP Routing
• Appendix F. RFC1483 Quick Start (IP Routing with NAT)
  • IP Routing with NAT
• Appendix G. RFC1483 Quick Start (Bridging)
  • Bridging
• Appendix H. Craft Port Connection Pin-out