KROHNE OPTIFLEX 2200 C_F EN - Manual (Page 56)

4
ELECTRICAL CONNECTIONS
56
OPTIFLEX 2200 C/F
www.krohne.com 07/2013 - 4000668002 - HB OPTIFLEX 2200 R02 en
1 Remove the terminal compartment cover.
2 Remove the 4-pin connector.
3 Put the signal cable into the opening of the cable gland.
4 Put the electrical wires in the connector terminals. Tighten the terminal screws with a small
slotted-tip screwdriver. Make sure that the electrical wires agree with the terminals. For
more data, refer to the electrical schema in this section.
5 Put the connector into the 4-pin socket. Attach the Faston connector (drain wire).
6 Attach the terminal compartment cover.
7 Tighten the cable gland. Make sure that the probe housing is correctly sealed.
How to connect the signal cable to the probe housing
Figure 4-11: How to connect the signal cable to the probe housing
CAUTION!
Bending radius of the signal cable: ≥ 50 mm / 2
¨