NSi Industries K801Z - Manual (Page 3)

DESCRIPTION OF KEYS — See Figure 9
0-9 Serves to set load numbers, time, and day of week for ON/OFF entries as well as real time
and date.
Exit Allows unit to return to RUN MODE immediately after any entry.
AM/PM Used to set AM or PM.
YES Used to answer YES to questions posed by Controller, also enters information into the
memory. Confirmed by double audible
BEEP.
NO Used to answer NO to questions posed by Controller, or advance to the next instruction, or
delete any entry already in the REVIEW MODE.
Reverse Permits return to a previous question in the scheduling routine or enters options mode from
the run mode.
Enter Must be pressed to store entries into memory.
SET REAL TIME AND DATE
• Display is now showing: SET TIME HH:MM
• Using the appropriate numeric keys, enter time. Example: 09:30. If an error is made, key in all zeros and
begin again.
• Press AM/PM, then PRESS ENTER.
• Next display will show: SET DATE MM/DD/YY. Example: April, 2, 2000 = 04/02/00. PRESS ENTER.
• Unit will now proceed to the run mode and time, date, and day of the week will be displayed in rotating
order. Day of the week will automatically be displayed by date recognition.
• Familiarize yourself with the Controller by entering sample schedule provided.
• AT THIS TIME, LOAD SCHEDULES SHOULD BE PREPARED AND ENTERED ON SCHEDULE
SHEETS PROVIDED (REFER TO SAMPLE).
OPERATION
There are two modes of operation: RUN and SET.
RUN: The controller will display in sequence day, month, year, time of day in AM/PM or 24 hour format.
SET: To enter the set mode, PRESS ENTER or REVERSE. IN THIS MODE, IF NO ENTRIES ARE
MADE IN (5) MINUTES, UNIT WILL RETURN TO THE RUN MODE.
NOTE: If YES key is not pressed after any given entry, it will NOT be entered — likewise if EXIT key is
pressed.
In the SET MODE, the Controller will display and prompt the following:
1 — Set time
2 — Set date
3 — Set or review schedule
4 — Set or review holiday dates
5 — Set or review seasonal dates
6 — Enter options mode
2