NSi Industries K801Z User Manual
Page 5
DUTY CYCLE ASSIGNMENT
5. Duty Cycle?
There are 9 variations of duty cycles. If desired,
PRESS YES. If not, PRESS NO and proceed to Step #8.
NOTE: Duty cycle will always begin with the OFF cycle.
6. Enter duty cycle number which represents the pattern required (refer to schedule sheet).
PRESS
ENTER. PATTERN ITSELF WILL BE SET IN STEP #23.
7. Set ON Time
Enter the hours and minutes. Be sure AM/PM is correct.
PRESS ENTER.
NOTE: TO MAINTAIN ANY LOAD ON PAST MIDNIGHT, AN ADDITIONAL ON MUST BE ENTERED
FOR 12:00 AM.
8. Unit will now review the entire ON sequence —
Load number
Season number(s)
Days of week
Time ON
Duty cycle number
Unit will ask IS THIS OK?
If YES is pressed, above entries will be entered. If NO is pressed, above entries will be deleted.
9. Another Schedule Entry for Load #1?
PRESS YES because an OFF entry must be entered.
10a. Season number(s) previously set for ON will be displayed. Press the number of any season you want to
add or delete from the OFF entry.
PRESS ENTER.
10b. Days previously set for ON will be displayed.
Normally the same days scheduled for ON will be scheduled for OFF . . . however, if a different OFF time
is needed for one of the ON days, press that day’s button to delete it. When the desired OFF days are
displayed,
PRESS ENTER. Seasonal holiday number(s) will be displayed. PRESS ENTER. TURN LOAD
ON?
PRESS NO.
11.
Set OFF Time
Enter the hours and minutes. Be sure AM/PM is correct.
PRESS ENTER.
12.
Unit will now review entire OFF sequence —
Load number
Season number(s)
Days of week
Time OFF
Unit will ask IS THIS OK?
If YES is pressed, above entries will be entered. If NO is pressed, above entries will be deleted.
13.
Another Schedule Entry for Load #1?
If another schedule is required,
PRESS YES and follow above procedures. If no additional schedule is
required for load #1,
PRESS NO.
14.
Do You Want to Set or Review Schedules?
PRESS YES and enter schedules for all other load numbers following above procedures. After all are
entered, answer NO to question #14.
4