SHIMPO CEG-2000 - Manual (Page 14)

-11-
6.3.4 Polarity selection for each measuring unit
1) With “XDUCER” displayed, press the ENT key, and perform the set-up of each
measuring unit.
2) Use the up and down arrow keys to toggle between measuring units A-D and
“FINISH” as shown on the display. Select the name of the measuring unit to
change the settings for and press the ENT key.
• Select a letter A-D . . . to change the settings for a particular measuring unit.
• Select “FINISH”. . . . . to quit the set-up process.
Go to selections in “6.3.5 Item selection.”
3) With “POL” displayed, press the ENT key. Set the polarities for each measuring
unit.
4) Use the up and down arrow keys to select “+” or “–”, and then press the ENT
key.
5) Return to step 2) above.
6.3.5 Selection of items
1) With “ITEM” and the eight-digit display visible, press the ENT key. Then, enter
the settings for each item.
2) Use the up and down arrow keys to toggle between item numbers 1-3 and
“FINISH” as shown on the display. Select the name of the item to change the
settings for.
3) Select the name of the item to change the settings for and press the ENT key.
Measuring method
Selection of POL
Internal diameter measurement
Direct Direct
Using levers
PG Type
External diameter measurement Height
measurement
Using levers
OG Type
+ + +
Select item 1 or 2 6.3.6 Input channel selection
Select item 3
6.3.11 Selecting the calculation
method
Select finish 6.3.12 Save setting values