SHIMPO CEG-2000 - Manual (Page 23)

-20-
6.5 Program Switching Mode
(1) In Measurement Mode, hold down the down arrow
key for at least two seconds.
(2) The “SET” LED (green) will light up, “PROG” will
be displayed, and the unit will enter Program
Switching Mode.
(3) Press the ENT key.
(4) The program that is currently in use is indicated by
a number 0-9.
(5) Using the up and down arrow keys, select the
number of the program number to be used.
(6) After making a selection, press the ENT key.
(7) This will quit Program Switching Mode and return
to Measurement Mode.
(8) After a new program number has been selected, it
may be necessary to perform master matching. If a
measuring device has been replaced, it may be
necessary to adjust the detector.
(9) In order to perform set-up, first switch to the new
program number and then enter Set-up Mode.
(10) When power is turned on, the most recently
selected program is launched.
RST
ENT
MAS SET
1 2 3
SET MAS
1)
RST
ENT
MAS SET
1 2 3
SET MAS
2)
3)
RST
ENT
MAS SET
1 2 3
SET MAS
4)
6)
5)