SHIMPO CEG-2000 - Manual (Page 24)

-21-
7 An explanation of input and output
7.1 Serial output (RS232C)
7.1.1 Overview
Through the RS232C, this unit is capable of outputting measured values to a printer
or sending the data to a PC. The following information can be sent to a PC:
(1) Measurement items
Items 1-3
(2) Measured values The data shown in the unit's eight-digit display, Use None
(3) Decision +Not OK, OK, –Not OK, NJG (only with “Use None”)
7.1.2 Preparation
This units RS232C port enables it to output data. Please connect the optional D-
sub9C (male) communications cable to this unit’s RS232C port. Three different
optional communications cables are available for different applications. For details,
please refer to 9. “Options.”
7.1.3 Serial port settings
Baud rate 9,600
Bits/text 8
Stop bit 1
Start bit 1
Parity bit None
7.1.4 Composition of transmitted data
Item 1 (five digits), space (one digit), measured value (eight digits), space (one digit),
decision (three digits), space (one digit).
Item 2 (five digits), space (one digit), measured value (eight digits), space (one digit),
decision (three digits), space (one digit).
Item 3 (five digits), space (one digit), measured value (eight digits), space (one digit),
decision (three digits), CR, LF.
7.1.5 Method of data transmission to PCs
In Measurement Mode, press the ENT key. This will switch to the Hold Measured
Value Mode described in 6.2.2, and will transmit the measured value. If the master
match was unsuccessful data will not be transmitted.
I T E M 1
I T E M 2
I T E M 3 CR LF
Decision
Decision
Decision
Measured value
Measured value
Measured value