SHIMPO CEG-2000 - Manual (Page 18)

-15-
6.4 Master Matching Mode
6.4.1 Master matching
1) In Set-up Mode, hold down the right arrow (MAS)
key for at least two seconds.
2) The “MAS” LED (orange) will light up and “MIN
M.” will be displayed, switching to “Master
Matching.”
3) When “ALL” is selected under “Master Match
Selection (MAS SET)” in Setting Mode, master
matching will be done all at once. If “EACH” is
selected, master matching will be performed one at
a time.
4) When master matching is performed one at a time,
master matching is performed for the item currently
shown in the bar display. Use the up and down
arrow keys to toggle between the items that master
matching will be performed on. The Item/Decision
Lamps show which item is currently shown in the
bar display.
When “1” is lit, it means that Item 1 is displayed.
When “2” is lit, it means that Item 2 is displayed.
5) Set the small master to a detector, and when the bar
display stabilizes, press the ENT key.
RST
ENT
MAS SET
1 2 3
SET MAS
1)
RST
ENT
MAS SET
1 2 3
SET MAS
4)
5)
2)