West Control Solutions KS 42-1 - Manual (Page 38)

5.2 Parameters
Parameter setting level
Operating KS4x-1 38 Parameters
Cntr
Name Value range Description Default
Pb1
1...9999 1 Proportional band 1/2 (heating) in phys. dimensions (e.g. °C) 100
Pb2
1...9999 1 Proportional band 2 (cooling) in phys. dimensions (e.g. °C) 100
ti1 1...9999 Integral action time 1 (heating) [s] 180
ti2 1...9999 Integral action time 2 (cooling) [s] 180
td1 1...9999 Derivative action time 1 (heating) [s] 180
td2
1...9999 Derivative action time 2 (cooling) [s] 180
t1
t2
0,4...9999 Minimal cycle duration 1/2 (heating/cooling) [s]. The minimum
impulse is 1/4 x t1/t2
10
SH
0...9999 Dead zone or switching differential for on-off control [phys.
dimensions)
2
d.SP -1999...9999 Trigger point speration for series contact
D / Y / Off [phys.
dimensions]
100
tP
0,1...9999 Minimum impulse [s] OFF
tt 3...9999 Actuator response time for servo-motor [s] 60
Y2 -120...120 2. correcting variable 0
Y.Lo
-120...120 Lower output limit [%] 0
Y.Hi
-120...120 Upper output limit [%] 100
Y.0
-120...120 Working point for the correcting variable [%] 0
Ym.H -120...120 Limitation of the mean value Ym [%] 5
L.Ym 0...9999 Max. deviation xw at the start of mean value calculation [phys.
dimensions]
8
1 Valid for ConF/ othr/ DP = 0. At DP = 1/ 2/ 3 also 0,1 / 0,01 / 0,001.
SEtP
Name Value range Description Default
SP.LO -1999...9999 Set-point limit low for Weff 0
SP.Hi -1999...9999 Set-point limit high for Weff 900
SP.2
-1999...9999 Set-point 2. 0
r.SP
0...9999 Set-point gradient [/min] OFF
t.SP 0...9999 Timer time [min] 5
SP -1999...9999 Set-point (only visible with BlueControl!) 0
ProG
Name Value range Description Default
SP.01
-1999...9999 Segment end set-point 1 100 1
Pt.01
0...9999 Segment time 1 [min] 10 2
SP.02 -1999...9999 Segment end set-point 2 100 1
Pt.02 0...9999 Segment time 2 [min] 10 2
SP.03 -1999...9999 Segment end set-point 3 200 1
Pt.03
0...9999 Segment time 3 [min] 10 2