West Control Solutions KS 42-1 - Manual (Page 39)

g
Resetting the controller configuration to factory setting (Default)
r chapter 12.1 (page 56)
Parameter setting level
Operating KS4x-1 39 Parameters
Name Value range Description Default
SP.04 -1999...9999 Segment end set-point 4 200 1
Pt.04 0...9999 Segment time 4 [min] 10 2
1 If SP.01 … SP.04 = OFF then following parameters are not shown
2 If segment end set-point = OFF then the segment time is not visible
InP.1
Name Value range Description Default
InL.1
-1999...9999 Input value for the lower scaling point 0
OuL.1 -1999...9999 Displayed value for the lower scaling point 0
InH.1 -1999...9999 Input value for the upper scaling point 20
OuH.1 -1999...9999 Displayed value for the lower scaling point 20
t.F1
-1999...9999 Filter time constant [s] 0,5
InP.2
Name Value range Description Default
InL.2
-1999...9999 Input value for the lower scaling point 0
OuL.2
-1999...9999 Displayed value for the lower scaling point 0
InH.2 -1999...9999 Input value for the upper scaling point 50
OuH.2 -1999...9999 Displayed value for the upper scaling point 50
Lim
Name Value range Description Default
L.1 -1999...9999 Lower limit 1 -10
H.1 -1999...9999 Upper limit 1 10
HYS.1
0...9999 Hysteresis limit 1 1
L.2
-1999...9999 Lower limit 2 OFF
H.2
-1999...9999 Upper limit 2 OFF
HYS.2 0...9999 Hysteresis limit 2 1
L.3 -1999...9999 Lower limit 3 OFF
H.3 -1999...9999 Upper limit 3 OFF
HYS.3
0...9999 Hysteresis limit 3 1
HC.A
-1999...9999 Heat current control limit [A] 50