Badger Meter GALAXY - Manual (Page 22)

TROUBLESHOOTING
IR Reading Error
Figure 33: Reading failure message
If you receive an error message similar to the screen shown here when attempting an IR read, review this checklist to try and
correct the error before attempting to read again
Use Correct IR Cable
Make sure you are using the correct IR cable The table below lists the part number of the IR cable to be used with TR3 and TR2
endpoints
If the endpoint looks like... Use IR cable with part number...
TR3 or TR2 64436-023 NOTE: N IR220Lplus is displayed
on the label
64436-030 NOTE: N IR220LN9.6 is displayed
on the label
TR2
(pit or
original
remote
endpoint)
64976-013 NOTE: N Use IR cable
PN: 64976-013 only
with the TR2 endpoints
pictured
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 22 February 2013