Badger Meter GALAXY - Manual (Page 8)

TR3 ENDPOINT
Figure 6: GALAXY TR3 endpoint
TR3 Programming Screen
The following buttons and fields are included on the TR3 programming screen as shown in Figure 7 on the next page
Buttons
Program Programs a reading into an RTR endpoint, most commonly after a tamper repair This button is not
active when reading an ADE or HR-E LCD encoder
Start Radio Starts the endpoint radio
Pause Radio Pauses the endpoint radio
Stop Radio Stops the endpoint radio
Force RF Forces an endpoint transmission
Reading Tapping the button activates the Reading field
Read Reg Reads the register of an ADE or HR-E LCD encoder, most commonly to verify a tamper repair This
button is not active when reading an RTR endpoint
Fields
ID/Serial # Endpoint serial number
Firmware Ver. Endpoint firmware version
Type Encoder type
Xmit Intrvl Radio transmission interval in minutes
Xmit Count Active count of radio transmissions during the life of the endpoint
NOTE: N To perform any of the GALAXY Programmer software functions, remove the cover (PN: 66367-001) of the TR3
endpoint to access the IR port To remove, squeeze the long sides of the cover at the midpoint and pull
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 8 February 2013