Badger Meter High Resolution LCD Encoders (HR-E LCD) - Manual (Page 16)

HR | E LCD Encoder
PROGRAMMING THE HR-E LCD ENCODER
From the Programmer screen, you can view and change the parameters that are currently programmed into the HR-E LCD
Encoder, as well as load new parameters into the HR-E LCD Encoder You can also clear the encoder's reading
Select the COM Port
The software communicates to the HR-E LCD Encoder via the selected COM Port. From the IR Port drop-down menu, select the
COM port connected to the encoder
Perform a Read
Click on the Read option
If the correct COM port is selected and a good response is received, the software delays a short time then populates the
Programmer screen data fields with the information from the encoder
If the encoder is programmed the way you want, just disconnect it from the IR bracket If not, see "Change Current Settings"
on page 17
Page 16 December 2012