Bulletin f-70 – Dwyer UXF2 User Manual
Page 46
- 36 -
(4) Setting the range: to full scale.
Proceed to the following from the measurement mode.
Keying LCD
indication/comment
key pressed twice.
1st line: [OUTPUT SETUP].
ENT
key pressed.
1st line: [ZERO ADJUST].
key pressed 4 times.
1st line: [RANGE]. 2nd line: [FLOW RATE].
ENT
key pressed.
2nd line blinks.
ENT
key pressed to enter.
1st line: [FLOW SPAN-1]. 2nd line: [10.0 L/s]. * As selected currently.
ENT
key pressed.
Cursor blinks on 2nd line.
and
key
pressed.
Until the range is set to a desired value. Setting is available from 0.3 to 10 m/s
in terms of velocity.
Operate
to select a numeric or point, and
to shift the place.
ENT
key pressed.
Registered after [**COMPLETE**] is displayed about 1 sec on 2nd line.
ESC
key pressed 3 times.
1st line [OUTPUT SETUP].
key pressed 3 times.
Resumes the measurement mode.
BULLETIN F-70