How to set the total unit, Bulletin f-70 – Dwyer UXF2 User Manual
Page 86
- 76 -
4.6.3. How to set the total unit
Description
z
Select the totalizer unit of volume.
z
Metric system
Total··························· mL (factory set), L, m
3
, km
3
, Mm
3
, mBBL, BBL, kBBL
z
Inch system
Total··························· gal, kgal, ft
3
, kft
3
, Mft
3
, mBBL, BBL, kBBL, ACRE-in, ACRE-ft
<Caution> First, set the unit system (metric or inch) according to Section 4.6.1.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand
(Section 4.4.1).
Typical operation Set the total unit to [m
3
].
Keying order
Description
Indication
ź
Pressed 3 times to indicate "MEASURE SETUP".
MEASURE SETUP
ENT
ź
Pressed to indicate "SYSTEM UNIT".
SYSTEM UNIT
METRIC
ź
Pressed twice to indicate "TOTAL UNIT".
TOTAL UNIT
mL
ENT
ź
Pressed to blink.
TOTAL UNIT
mL
ź
Pressed twice to select "m
3
".
TOTAL UNIT
m3
Pressed to register it.
TOTAL UNIT
½½ COMPLETE ½½
Ļ
ENT
ź
ź
ź
ź
--- "m
3
" registered.---
TOTAL UNIT
m3
ESC
Press
ESC
key once, and
key twice to resume
the measurement mode.
0.00 m3/h
+ 0.00 m3
BULLETIN F-70