Milestone XProtect Go 2014 - Manual (Page 136)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 136 Advanced configuration
Name Description
Online
Select the required profile (for example Always on) for the online
schedule (see "Configure camera-specific schedules" on page 68)
for the relevant camera(s).
You specify a camera's online periods by creating schedule profiles
based on:

Periods of time (example: Mondays from 08.30 until 17.45),
shown in pink:

Events within periods of time (example: from Event A occurs
until Event B occurs Mondays from 08.30 until 17.45),
shown in yellow:
The two options can be combined , but they cannot
overlap in time.
Tip: If you want to view live video as well as record video from a camera outside its online recording
schedule, you can select the
Start cameras on client requests (see " Scheduling options " on page 134)
and, if needed, the Enable recording when started on client request (see " Scheduling options " on
page 134) options to set up your scheduling properties for a relevant camera.
Speedup
Speedup may also take place based on events, but that is configured elsewhere. See Frame rate -
MJPEG (General recording and storage properties) (see "Frame rate - MJPEG" on page 81) and
Video (Camera-specific properties) (see "Video" on page 88).
Name Description
Speedup
For specific MJPEG cameras, specify speedup periods. Before you
can define this type of schedule, you must enable (see "Frame rate
- MJPEG" on page 81) speedup. You specify a camera's speedup
periods by creating schedule profiles based on periods of time
(example: Mondays from 08.30 until 17.45), shown in olive green:
PTZ patrolling
When you configure scheduling (see "Configure camera-specific schedules" on page 68) for PTZ
(pan-tilt-zoom) cameras capable of patrolling (see "PTZ patrolling" on page 104), you can specify
which patrolling profiles to use at specific times. Before you can define this type of schedule, you must
configure patrolling for the relevant cameras.