Milestone XProtect Go 2014 - Manual (Page 162)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 162 Advanced configuration
Language support and XML encoding
You can select the language/character set that should be used by your system's server and clients.
Component Requirement
Character encoding/Language
Select required language/character set.
Example: If the surveillance server runs a Japanese version of
Windows, select Japanese. Provided access clients also use a
Japanese version of Windows, this will ensure that the correct
language and character encoding is used in clients' communication
with the server. If you are using a master/slave setup, remember to
specify the same language/character set on all relevant servers.
Master/Slave
About master and slave
You can create a master/slave setup of your system servers. A master/slave setup allows remote
users to transparently connect to more than one server at the same time. When remote users connect
to the master server, they instantly get access to the slave servers as well.
You can designate one server per Software License Code (SLC) as master server and an unlimited
number of slave servers. To check the connection of your slave servers, you can verify the connection
to your slaves by clicking Update Status and let the system report the number of connected slaves
back to you.
Configure master and slave servers
1. Expand Advanced Configuration, right-click Master/Slave and select Properties.
2. Select the Enable as master server check box.
3. Click Add to add a slave server.
4. Specify slave server properties. When ready, click OK.
Master/slave properties
You can set the following properties for master servers and slave servers:
Master server properties
Properties available in XProtect Enterprise and XProtect Professional only: