Milestone XProtect Go 2014 - Manual (Page 193)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 193 Settings
o If your system should show live video when you preview camera or if you would rather see
a snapshot or no preview of the camera.
Click Restore Default Settings below the behavior list to restore your system to its default behavior.
Default File Paths
Your system uses a number of default file paths:
File paths Description
Default recording path for new
cameras
All new cameras you add use this path by default for storing
recordings. If required, you can change individual cameras'
recording paths as part of their individual configuration (see
"Recording and archiving paths" on page 93), but you can also
change the default recording path so all new cameras you add use
a path of your choice.
Default archiving path for new
cameras
All new cameras you add use this path by default for archiving (see
"About archiving" on page 127). If required, you can change
individual cameras' archiving paths as part of their individual
configuration, but you can also change the default recording path so
all new cameras you add use a path of your choice. Note that
camera-specific archiving paths are not relevant if you use dynamic
path selection (see "Dynamic path selection (properties)" on page
74) for archiving.
Configuration path The path by default used for storing your system configuration.
Analytics Event Settings
Analytics Event Settings let you specify the following:
Name Description
Enabled Lets you enable the analytics event feature
Port
Specify the port used by this service. Default port is 9090.
Make sure that relevant VCA tool providers also use this port
number. If you change the port number, make sure that VCA tool
providers change their port number accordingly.