Milestone XProtect Go 2014 - Manual (Page 50)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 50 Getting started
Name Description
Seconds [of post-recording]
Specify the number of seconds for which you want to record video
from after recording stop conditions (that is motion or stop event)
are met. Usually, only some seconds of post-recording is required,
but you can specify up to 65535 seconds of post-recording,
corresponding to 18 hours, 12 minutes and 15 seconds. However, if
specifying a very long post-recording time, you can potentially run
into a scenario where your post-recording time spans scheduled or
unscheduled archiving times. That can be problematic since post-
recording does not work well during archiving.
Properties available in XProtect Enterprise and XProtect Professional only:
Keyframe Only
Select Keyframe only if you want motion detection to take place
only on keyframes of the video stream to reduce the system
resources used on motion detection.
The template can help you configure similar properties quickly. For example, if you have 20 cameras
and you want a particular frame rate on all of them, you can enter it once in the template, and then
apply the template to the 20 cameras.
Name Description
Apply Template
Select which cameras you want to apply the template for. Use one
of the two Set buttons to actually apply the template.
Select All Click button to select all cameras in the Apply Template column.
Clear All Click button to clear all selections in the Apply Template column.
Apply template on selected
cameras
Apply the value from the template to selected cameras.
Configure storage: Drive selection
Specify which drives you want to store cameras' recordings on. You can specify separate drives/paths
for recording and archiving (see "About archiving" on page 127).
Properties available for all XProtect software versions:
Name Description
Drive Letter representing the drive in question, for example C:.