Milestone XProtect Go 2014 - Manual (Page 48)

Milestone XProtect ® Go 2014 Administrator's Manual
www.milestonesys.com 48 Getting started
Recording Frame Rate
Required average frame rate for recorded video from the camera.
Select number of frames, then select the time unit interval (second,
minute or hour). The frame rate must be higher than the frame rate
specified under normal mode.
Properties available in all XProtect software versions:
The template can help you configure similar properties quickly. For example, if you have 20 cameras
and you want a particular frame rate on all of them, you can enter it once in the template, and then
apply the template to the 20 cameras.
Name Description
Apply Template
Select which cameras you want to apply the template for. Use one
of the two Set buttons to actually apply the template.
Select All Click button to select all cameras in the Apply Template column.
Clear All Click button to clear all selections in the Apply Template column.
Apply template on selected
cameras
Apply the value from the template to selected cameras.
Configure storage: Live and recording settings (MPEG cameras)
This wizard page only appears if one or more of your cameras use the MPEG video format.
Specify which frame rate to use for each camera, and whether to record all frames or keyframes only.
You can also select pre- and post-recording, allowing you to store recordings from periods preceding
and following detected motion and/or specified events.
Note that all of the properties can also be specified individually for each camera.
Properties available in all XProtect software versions:
Name Description
Live Frame Rate
Required average frame rate for live video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour).
If the camera supports dual stream and dual stream is enabled, the
Live Frame Rate column will be read-only with the value Dual
streaming
—which cannot be altered.