NORD Drivesystems BU0590 - Manual (Page 40)

PROFINET bus module for NORD frequency inverters SK 5xxE
40 Subject to technical amendments BU 0590 GB-0312
Parameter
{Factory setting}
Setting value / Description / Note Device Supervisor Parameter set
P545
Bus actual value 3
(Actual bus value 3)
up to
SK 535E
S P
0 ... 24
{ 0 }
This parameter is identical to P543.
Condition is PPO 2 or PPO 4 type (P507).
P546
Function Bus setpoint 1
(Function of bus - setpoint 1)
up to
SK 535E
S P
0 ... 55
{ 1 }
In this parameter, a function is allocated to the output setpoint 1 during bus actuation.
The possible analog functions can be found in the following table.
NOTE: For further details please refer to the manual BU0500 (P400, P546), the relevant
BUS operating manual or the supplementary POSICON manual BU0510.
P546 [-01]
...
[-05]
Function Bus setpoint
(Function bus - setpoints)
SK 540E and
above
S P
In this parameter, during bus actuation a function is allocated to the setpoint provided.
NOTE: The setpoints 4 and 5 must be supported by the relevant bus module. For further
details, please refer to manual BU0500 (P400, P546), the relevant BUS operating
manual or the supplementary POSICON manual BU0510.
[-01] = Bus setpoint 1 [-02] = Bus setpoint 2 [-03] = Bus setpoint 3
[-04] = Bus setpoint 4 [-05] = Bus setpoint 5
0 ... 57
{ [-01] = 1 }
all other { 0 }
0 = Off
1 = Setpoint frequency
2 = Torque current limit (P112)
3 = Actual frequency PID
4 = Frequency addition
5 = Frequency subtraction
6 = Current limit (P536)
7 = Maximum frequency (P105)
8 = Actual PID frequency limited
9 = Actual PID frequency monitored
10 = Torque servo mode (P300)
11 = Torque precontrol (P214)
12 = Reserved
13 = Multiplication
14 = Process controller actual value
15 = Process controller setpoint
16 = Process controller lead
17 = BusIO In Bits 0...7
18 = Curve travel calculator
19 = Set relays, "Output status"
(P434/441/450/455=38)
20 = Set analog output (P418=31)
21 = …45 reserved from SK 530E and above
 BU 0510
46 = Setval.torque p.reg., "Setpoint torque
process controller"
47 = reserved from SK 530E and above 
BU 0510
48 = Motor temperature (SK 540E and above)
49 = reserved from SK 540E and above

BU 0510
53 = d-correction F process (SK 540E and
above)
54 = d-correction Torque (SK 540E and above)
55 = d-correction F+torque (SK 540E and
above)
56 = reserved from SK 540E and above 
BU 0510
57 = reserved from SK 540E and above 
BU 0510