Brother PR-1000 - Manual (Page 17)

16
j
Select the connecting position for the second
pattern, and then press
. In this
example, select the center point of the left
edge.
a Reference edge and reference point
b Second pattern [2]
c First pattern [1]
→ Message appears on screen and carriage will move
after pressing .
k
Prepare two embroidery positioning stickers.
We will follow the on-screen instructions to
affix these two stickers to the fabric so that
the positioning marks can be detected by the
camera.
l
Affix the first embroidery positioning sticker
onto the fabric within the red lines by using
both hands to press down on each corner of
the sticker. Affix the sticker with the large
circle to the top as shown on machine. Then,
press .
→ The camera detects the first positioning sticker.
Note
• Using and in this screen, the position of the
second pattern can be changed. For details, refer to
“Sliding the Position of the Pattern to be Connected”
on page 27.
c
a
b
Note
• Use the positioning stickers included with this
product or purchase replacement stickers (SAEPS2,
EPS2: XF0763-001) from your Brother dealer. If any
other sticker is used, the camera may not recognize
it.
• The 182 mm × 257 mm (7 inches × 10 inches)
embroidery positioning sticker sheet with strong
adhesive is most appropriate for connecting patterns
(SAEPS2, EPS2: XF0763-001). If any other
positioning sticker is used, it may peel off. If the
sticker peels off, the patterns cannot be connected.