Brother PR-1000 - Manual (Page 18)

17
m
Using both hands affix the second embroidery
positioning mark within the red lines by
pressing down on each corner of the
positioning mark onto the material and then
touch .
→ The camera detects the second positioning sticker.
Note
• Use new positioning stickers. If a sticker is reused, it
may easily peel off. If the sticker peels off during this
procedure, the patterns cannot be connected. Start
the project again with new fabric and stabilizer.
• Using fingers apply pressure to the corners of the
positioning sticker to firmly affix it to the fabric. If the
sticker is not firmly attached, the camera may
incorrectly detect the sticker.
• If any of the following messages appear, reattach
the positioning sticker in the correct position. Make
sure that the sticker is affixed with the large circle at
the top.