Brother PR-1000 - Manual (Page 22)

21
u
Select the connecting position for the third
pattern and then press
. In this
example, we will select the left point of the
top edge for the third pattern.
• Pattern rotates automatically when corner position is
selected.
a Reference edge and reference point
b Third pattern [3]
c Second pattern [2]
v
Follow the on-screen instruction to perform
steps
k
to
p
.
w
Press , then press and then
press the start/stop button to embroider the
third pattern.
→ After embroidering of the third pattern is finished,
the following message appears. When finished
connecting patterns, press .
→ After embroidering is finished, at the top left
side of the screen disappears.
The three patterns have been connected.
Press to clear the pattern.
Changing the Position of a Sticker
If the selected pattern or positioning stickers for
connecting the next pattern do not easily fit in the
embroidering area, follow the on-screen instructions
that appear after step
m on page 17 in order to move
the positioning stickers.
For an example, the on-screen instruction appears
when you use the embroidery frame with a size of 10
cm × 10 cm (4 inches × 4 inches) to connect patterns as
shown below.
a Pattern1.pes
b Pattern2.pes
b
a
c