Brother PR-1000 - Manual (Page 19)

18
n
After the two positioning stickers have been
detected, the following message appears.
a Embroidering area
While making sure that the two positioning
stickers do not peel off, remove the
embroidery frame from the machine, and
then rehoop the fabric. Be sure to hoop the
fabric so the next pattern and both the
positioning stickers are within the embroidery
sewing area. Reattach the frame and press
.
b Pattern to be embroidered next
c Centers of large circles for stickers
d Embroidery sheet
o
Select the area containing one of the two
stickers, and then press .
→ The camera detects the two positioning stickers.
a
Note
• If the next pattern and the centers of the large circles
of the two positioning stickers do not fit within the
embroidering area, use a larger embroidery frame. If
a larger embroidery frame cannot be used, continue
to step
o , and then refer to “Changing the Position
of a Sticker” on page 21 to reposition the sticker.
• If the sticker peels off during this procedure, the
patterns cannot be connected. If this occurs, restart
the procedure from the beginning.