Brother PR-1000 - Manual (Page 4)

3
DISPLAYING THE FABRIC WHILE ALIGNING THE
EMBROIDERY POSITION
The fabric hooped in the embroidery frame can be
displayed on the LCD so that the embroidery position
can be aligned.
This feature can be used from the pattern editing screen
and embroidering settings screen.
a
Hoop the fabric in the embroidery frame, and
then attach the frame to the embroidery
machine.
b
Select the pattern, and then press .
c
Press .
d
When the following message appears, press
.
→ The embroidery frame moves so the fabric can be
scanned.
Note
• When installing the following optional frame, the
built-in camera cannot be used to align the
embroidering position:
Cylinder frame, 80 mm (H) × 90 mm (W) (3 inches
(H) × 3-1/2 inches (W))
Wide cap frame, 60 mm (H) × 360 mm (W) (2-3/8
inches (H) × 14 inches (W))
Advanced cap frame 2, 60 mm (H) × 130 mm (W)
(2-3/8 inches (H) × 5-1/8 inches (W))
Advanced cap frame, 50 mm (H) × 130 mm (W) (2
inches (H) × 5-1/8 inches (W)).
• For details on using fabric thicker than 2 mm, refer
to “Positioning the pattern on thick fabric” (page 5).
Note
• Check page 7/7 of Settings screen to make sure the
“Fabric Thickness Sensor” is set to “OFF” when
using light to medium weight fabrics.