Brother PE-DESIGN Ver.432 - Manual (Page 155)

145
Contents
Bef
ore Using
Getting Star
ted
Design Center
La
y
out & Editing
File Utility
Programma
bl
e
Stich Creator
Quic
k Ref
erence
Alphabetic Inde
x
To set the region sewing attributes, click the Region sewing tab. You can only change the settings
of the stitch selected in the Region sew type selector of the Sewing Attributes bar. The other stitch
settings display in gray. When you select a text pattern or the Text entering mode, the Region sew-
ing tab displays automatically.
When the Fill Stitch is selected in the of the Region sew type selector, the Sewing Attribute Setting
displays like this.
Line sewing attributes
Zigzag stitch
ZigZag width
Sets the width of the zigzag stitch (when Zigzag Stitch is selected for the outline).
Range: 1 ~ 10 mm (0.04 ~ 0.39 inch)
Default: 2 mm (0.08 inch)
Density
Sets the number of lines per inch (when Zigzag Stitch is selected for the outline).
Range: 1 ~ 7 lines per mm (25 ~ 178 lines per inch)
Default: 4.5 lines per mm (114 lines per inch)
Running stitch
Run pitch
Sets the pitch of the line sewing (when Running Stitch is selected for the outline).
Range: 1 ~ 10 mm (0.04 ~ 0.39 inch)
Default: 2 mm (0.08 inch)
Run times
Sets the number of times the border will be sewn (when Running Stitch is
selected for the outline).
Range: 1 ~ 5
Default: 1
◆ Enter the desired values for each set-
ting either by clicking on the arrows or
by typing the value directly in the edit
box window.
• When you click a selector, a preview
image of that setting displays.
The image will change and reflect your
setting changes each time you click an
arrow.
◆ To restore the default value of an indi-
vidual setting, click its
Default button.
◆ Click Apply to confirm the settings.
◆ Click Close to exit.
Region sewing attributes
Fill stitch, Satin stitch and Programmed fill stitch:
Under sewing
Sets under sewing on/off. Try to use Under sewing for wide areas, in
order to prevent shrinking during stitching. Depending on the shape
of the region, however, it may not be possible to make this setting.
Density
Sets the number of lines per mm.
Range: 1 ~ 7 lines per mm (25 ~ 178 lines per inch)
Default: 4.5 lines per mm (114 lines per inch)