Step 3 converting to line image, Converting to line image, Step 3 – Brother PE-DESIGN Ver.432 User Manual
Page 22
12
Step 3
Converting to Line Image
1
Move to line image: Click
Stage
on the menu bar, then click
To Line Image
on the submenu. You can
also click the button of the Toolbar shown below:
NOTE:
Many menu functions can be activated by clicking a button on the Toolbar.
The
Cut out to Line Image
dialog will display. In this dialog, you will select the color(s) that will be
used to make the outline of the bitmap image.
2
When you click
OK
, the line image displays.
◆
If necessary, scroll and zoom the image.
◆
Move the cursor over the image. Its shape
changes to
. Click on any point of the outline.
The selected color displays in the upper box
under
Pick Colors
and a
appears in the
check box to show that the color is selected.
•
When the outline of the bitmap image uses more
than one color, you can repeat to select a total of
five colors. If you try to select more, colors are
scrolled down, and the color that was at the bot-
tom is deselected.
•
If you selected a color by mistake, simply click its
check box to deselect it.
◆
Click
View
to see the effect of your selection.
•
If you wanted to select another choice of color,
click
Cancel
. The bitmap image displays again
and you can repeat this step with another
color.
◆
If your preview image looks like the one shown
here, click
OK
to confirm the outline of your pat-
tern.
◆
Click
Cancel
to exit and go back to the bitmap
image.
•
At this stage, the data can be saved as a
*.pel
file.