Error messages – Brother PE-DESIGN Ver.432 User Manual
Page 176
166
Error Messages
The application is able to detect problems that may occur before or during data transfer. Here is the com-
plete list of error messages that may appear.
1
If the card module is not correctly connected:
2
If there is no card in the card module:
3
If a read-only card is inserted:
4
If an incorrect or defective card is inserted:
5
If a defect is detected after writing has already started, or if you remove the card while writing is in
progress, writing will stop and this message will display:
◆
Correct the connection between the
card module and the computer.
Check that the module is powered.
◆
Click
Retry
to start reading.
◆
Click
Cancel
to exit.
◆
Insert an Original card in the mod-
ule.
◆
Click
Retry
to start reading.
◆
Click
Cancel
to exit.
◆
Insert an Original card in the mod-
ule.
◆
Click
Retry
to start reading.
◆
Click
Cancel
to exit.
◆
Insert an Original card in the mod-
ule.
◆
Click
Retry
to start reading.
◆
Click
Cancel
to exit.
◆
Click
OK
to remove the message.