Brother PE-DESIGN Ver.432 User Manual
Page 97
87
Stage 3. In that case, a message will ask you to confirm that you want to abandon the changes
made in Stage 3.
Note that if you started in Stage 3 by opening a Stage 3 file, you cannot go to Stage 2.
If you were in Stage 1, this dialog displays.
2
When you click
OK
, the black and white image is displayed and you are in Stage 2.
Note that all the colors that you selected and turned on are converted to black. It is recommended
to select just as many colors as necessary to have a good outline of the image. In the above exam-
ple, a single color was selected.
In Stage 2, you can edit the image using the pens and erasers and use the zooming tools.
Note that if you do not like the result, you can go back to Stage 1 and select different colors.
See also:
“To Original Image” above, “To Figure Handle” and “To Sew Setting” below
◆
If necessary, scroll and zoom the image.
◆
Select the color(s) that you want to convert into
black. To do this, move the cursor over the
image. The shape changes to
. Click on a
color. The color moves to the upper box under
Pick Color
s and a
appears in the check box
to show that the color is on. You can repeat to
select a total of five colors. If you try to select
more, colors are scrolled down, and the color
that was at the bottom is deselected.
•
If you selected a color by mistake, simply click
its check box to deselect it.
◆
Click
View
to see the effect of your selection.
You can repeat this step after clicking on the
check boxes of the selected colors to toggle
them on/off, or after selecting different colors.
◆
Click
OK
to confirm.
◆
Click
Cancel
to exit.