Brother PE-DESIGN Ver.432 - Manual (Page 52)

42
Contents
Bef
ore Using
Getting Star
ted
Design Center
La
y
out & Editing
File Utility
Programma
bl
e
Stich Creator
Quic
k Ref
erence
Alphabetic Inde
x
Step 17
Transferring the Data to a Card
Before you can actually sew your embroidery pattern, you must transfer it to an Original card.
1 Insert an Original card in the module.
2 Click File on the menu bar, then click Write to Card on the submenu.
You can also click on the button of the Toolbar shown below:
This dialog will display.
If the card module is not correctly connected or powered, if the card is not inserted or is defective,
you will see an error message. Refer to “Write to Card” on page 128 for more details.
NOTE:
You can also save the data to your disk as explained next, and then use the File Utility application to
transfer the data to the card. See “Writing to an Original Card” on page 164.
Step 18
Saving the File
Before quitting the application, you should save your file on disk to be able to retrieve it later.
1 Click File on the menu bar, then click Save on the submenu.
You can also click on the button of the Toolbar shown below:
If the file already exists on the disk (the file has been saved at least once), the file is saved imme-
diately.
2
If the file name is still Untitled or if, for any other reason, the file cannot be found on the disk, the
application will ask you to enter a file name and select a target folder.
◆ If the card is not brand new, make sure
that you want to erase the data that is
already stored on the card and click
OK .
◆ Click Cancel to exit.
◆ Select the drive, the folder and type the
file name.
◆ Click Save to save.
◆ Click Cancel to exit.