Canon DP-V3010 - Manual (Page 23)

23 Pairing
Pairing
This section describes how to pair the main unit with the display controller for the first time after purchase and how to
pair these devices again.
Pairing the Main Unit with the Display Controller
The main unit and display controller is connected 1 to 1 and an operation to recognize each other (pairing) is necessary.
Perform this operation after installing the main unit and display controller.
1. Connect the main unit to the display controller ( 19).
2. Turn on the power of the main unit ("Turning on the Power of the Main Unit" ( 22)).
This automatically completes pairing and the power indicator of the display controller lights green.
Note
• Directly pair the main unit and the display controller and then connect to your network environment. Correct pairing may
not be possible when multiple devices are connected to the network.
• If the button brightness setting of the display controller is sets to Off, it will not turn on when pairing completes. Set the
button brightness to 1, 2 or 3 if you want to verify when pairing completes ( 13).
• Manually configure the "IP Address" and "Subnet Mask" as necessary ( 49).
Pairing again
Pairing must be performed once more for example when a paired display controller is reconnected. The procedure is
as follows:
1. Connect the main unit to the display controller ( 19).
2. Enable communication between the main unit and the display controller.
Reset the network settings of the main unit.
To reset the pairing information, press and hold the main unit's F3 and F4 buttons simultaneously for about
3 seconds until the power indicator flashes green and "Configure an IP Address" is set to "Automatic".
Reset the network settings of the display controller.
To reset the pairing information, press and hold the display controller's , and SET buttons simultaneously for
about 3 seconds until the power indicator flashes green.
When resetting of pairing information is finished for both units and re-pairing is complete, the power indicator of the
display controller lights green.
Note
• Directly pair the main unit and the display controller and then connect to your network environment. Correct pairing may
not be possible when multiple devices are connected to the network.
• If the button brightness setting of the display controller is sets to Off, it will not turn on when pairing completes. Set the
button brightness to 1, 2 or 3 if you want to verify when pairing completes ( 13).
• Manually configure the "IP Address" and "Subnet Mask" as necessary ( 49).
COP
Y