Canon DP-V3010 - Manual (Page 37)

37 OSD Menu
Item Setting Options (underline indicates factory default)
Calibration Performs calibration based on set target values when "User 1-7" is selected for "Picture Mode".
Note
• When "Luminance" is set to high brightness, it may be calibrated beyond the brightness
adjustment range and set lower than the target value depending on the "Color Temperature"
setting. In that case, set the "Luminance" again.
Luminance Sets the target brightness.
48 to 200 cd/m
2
Color
Temperature Sets the target color temperature.
D93, D65, D61, D56, D50, DCI, Custom: Preset modes.
x, y: You can enter CIE x, y in increments of 0.001. "Custom" mode is entered automatically as you
type.
x: 0.260 to 0.360 (0.314)
y: 0.260 to 0.360 (0.351)
Gamma Sets the target gamma.
2.2, 2.35, 2.4, 2.6, Canon Log (WideDR 1.1)
Color Gamut Sets the target color gamut.
SMPTE-C, EBU, ITU-R BT.709, Adobe RGB, DCI, Native
Start Performs calibration.
LUT Import LUT can be imported when "User 1-7" or "Canon Log" is selected for "Picture Mode".
LUT Type (Gamma, Color Gamut): Select the LUT type.
File Name: Select a file.
Base Color Gamut (SMPTE-C, EBU, ITU-R BT.709, Adobe RGB, DCI, Native): Select the color
gamut used when creating the LUT (when "Color Gamut" under "LUT Type" is selected).
Execute: Performs import.
Anchor Adjustment Temporarily saves parameters while adjusting SHARPNESS, CHROMA, BRIGHTNESS, and
CONTRAST (anchor point setting).
OK: Performs anchor point setting.
Cancel: Returns to the previous screen without setting anchor point.
Reset Return "Picture Mode" to factory default. Note that in "User 1-7" mode where you are performing
calibration, the setting returns to the value after calibration instead of the factory default.
When selected, the message "Reset Adjustment settings to defaults?" appears.
OK: Performs reset.
Cancel: Returns to the previous screen without resetting.
COP
Y