Canon XA20 - Manual (Page 150)

Appendix: Menu Options Lists
150
• When [OLED Dimmer] is set to on, the camcorder's screen will automatically become dimmer if the
camcorder is left without any operation for 3 minutes. Operate any control on the camcorder to
return the screen to its previous setting.
[OLED Mirror Image]: When set to [i On], this function reverses the image on the screen horizontally
when you rotate the OLED panel 180 degrees toward the subject. In other words, the screen will show
a mirror image of the subject.
[OLED Color Balance]: Allows you to adjust the color balance of the OLED screen. Adjust the [B] (blue)
and [R] (red) bars by touching [+] and [-]. You can check the results on the screen.
[VF Brightness]: Sets the viewfinder screen to one of two brightness levels. You can use this to make
the screen brighter if it is difficult to see.
[Notification Sounds]: A beep will accompany some of the camcorder's operations.
• While pre-recording (A 91) is activated, the camcorder will not emit any notification sounds.
[Wireless Remote Control]: Allows the camcorder to be operated with the wireless controller.
[Tally Lamp]: Activates the tally lamp when the camcorder is recording, the wireless controller is being
operated, the battery level is low or a memory card is full. When set to [j Off], the tally lamp will not
turn on in these cases. The tally lamp is located on the handle unit so make sure you attach it to the
camcorder in advance.
[Powered IS Button]: Determines the operation mode of the assignable button set to [È Powered IS]
(A 63).
[Î Press and Hold]: Powered IS will be activated while you hold the button pressed down.
[Ï Toggle On/Off]: Each press of the button will turn the Powered IS function on and off.
[Set WB Priority]: You can press an assignable button set to [Ä WB Priority] to switch between the
current white balance and the white balance setting selected for [Set WB Priority].
[Focus/Zoom Ring Direction]: Changes the direction the focus/zoom ring needs to be turned.
[Focus/Zoom Ring Response]: Selects the sensitivity of the response when operating the focus/zoom
ring.
[Focus Preset Speed]: Determines the speed at which the focus changes to the preset position.
[Battery Info]: When you are using a battery pack that is compatible with Intelligent System, this option
displays a screen where you can verify the battery charge (as a percentage) and the remaining
recording time (
mode) or playback time ( mode).
• If the battery pack is exhausted, the battery information may not be displayed.
[HDMI Time Code]: When set to [i On], the HDMI signal output from the camcorder includes the
camcorder's time code.
[HDMI Status]: Displays a screen where you can verify the standard of the output signal from the HDMI
OUT terminal.
[Output Onscreen Displays]: When set to [i On], the camcorder’s onscreen displays will appear also
on the screen of a TV or monitor connected to the camcorder.
[Distance Units]: Selects the units to use for the focusing distance display while focusing manually. This
setting also affects units for GPS information when using the optional GP-E2 GPS Receiver.
COP
Y