Cop y – Canon XA20 User Manual

Page 21

Advertising
background image

Charging the Battery Pack

21

5 Charging will start when the camcorder is turned off.

• If the camcorder was on, the green POWER/CHG indicator

will go out when you turn off the camcorder. After a
moment, the POWER/CHG indicator will turn on in red
(battery pack charging). The red POWER/CHG indicator will
go out when the battery pack is fully charged.

• If the indicator flashes, refer to Troubleshooting (A 158).

To remove the battery pack

1 Slide d in the direction of the arrow and

hold it pressed down.

2 Slide the battery pack and then pull it out.

IMPORTANT

• Turn off the camcorder before connecting or disconnecting the compact power adapter. After you

turn off the camcorder, important data is updated on the memory card. Be sure to wait until the
green POWER/CHG indicator goes out.

• Do not connect to the camcorder’s DC IN terminal or to the compact power adapter any electrical

equipment that is not expressly recommended for use with this camcorder.

• To prevent equipment breakdowns and excessive heating, do not connect the supplied compact

power adapter to voltage converters for overseas travels or special power sources such as those on
aircraft and ships, DC-AC inverters, etc.

NOTES

• We recommend charging the battery pack in temperatures between 10 °C and 30 °C. If either the

ambient temperature or the battery pack’s temperature is outside the range of approx. 0 °C to
40 °C, charging will not start.

• The battery pack will be charged only when the camcorder is off.
• If the power supply was disconnected while charging a battery pack, make sure the POWER/CHG

indicator has gone out before restoring the power supply.

• If remaining battery time is an issue, you can power the camcorder using the compact power

adapter so the battery pack will not be consumed.

POWER/CHG (battery charging) indicator

BATTERY
RELEASE
switch

COP

Y

Advertising
This manual is related to the following products: