Canon REALiS SX80 Mark II D - Manual (Page 108)

Setting Various Function
108
Extending the Menu Display Time
[Other settings] - [Menu display time]
You can extend the menu display time,
which is 30 seconds usually, to 3 minutes.
Press the OK button to accept your setting
and then press the MENU button.
• [Normal] is the factory default.
• You cannot extend the display time for
the window indicating the completion of
Auto setup (
P53 ), the guide window
( P106 ), the lamp replacement window
(preparation) ( P145 ), or the lamp
replacement window (warning) ( P145 ).
• You cannot use the button holding oper-
ation except when you adjust the image
size (
P58 ) or focus ( P59 ).
Setting a Password
[Other settings] - [Password settings]
Disables the projector unless the correct pass-
word is entered.
Press the OK button to accept your setting and
then press the MENU button.
• [Off] is the factory default.
• You cannot set [On] unless you have com-
pleted [Register password].
Once you set a password, the password entry
screen appears at power-on.
Enter a 4-digit password with [ ] / [ ] / [<] / [>].
If the password is valid, the projection starts. If
you enter a wrong passwords three times, the
power will be turned off.
• The power is also turned off if no password is
inputted for 3 minutes.
HDMI COMPONENT
DIGITAL PC VIDEO/S-VIDEO
ANALOG PC USB
Normal The menu is displayed for 30 sec-
onds.
Extended The menu is displayed for 3 minutes.
Other settings
System settings
Menu display time
HDMI COMPONENT
DIGITAL PC VIDEO/S-VIDEO
ANALOG PC USB
Off The projector can be used even if no pass-
word is entered.
On The projector cannot be used unless you
enter your password.
Other settings
System settings
Password settings
<
<
To Cancel the Password
Turn off the projector and unplug the power
plug. Hold down the MENU button on the top
control and connect the power plug. Make
sure to keep holding down the MENU button
until a beep sounds. The password is can-
celled (the registered password is also reset).