Canon REALiS SX80 Mark II D - Manual (Page 80)

Setting Display Status
80
Selecting an Input Signal Type (ANALOG
PC)
[Input signal select]
You can select a proper resolution if auto
PC adjustment function (
P57 ) cannot
project a correct image from a computer.
Press the OK button to accept your setting
and then press the MENU button.
Select an input signal corresponding to
the resolution of the computer.
• For the signal types supported by the
projector, see the table on page 150 .
Selecting an Input Signal Type (VIDEO/S-
VIDEO*)
[Input signal select]
* is only applicable to SX80 MarkII
You can select a proper signal type if a
video image from your AV equipment is
not projected correctly.
Press the OK button to accept your setting
and then press the MENU button.
• [Auto] is the factory default.
• Refer to the User's Manual of your AV
equipment connected to the projector to
confirm the input signal type.
HDMI COMPONENT
DIGITAL PC VIDEO/S-VIDEO
ANALOG PC USB
Input signal select
Display settings
HDMI COMPONENT
DIGITAL PC VIDEO/S-VIDEO
ANALOG PC USB
Input signal select
Display settings